Our Work | Boiler & Heating Installations Sheffield | Gas Engineer Done Right Sheffield

Boiler installations

Combis, system boilers, relocations and changeovers.

Viessmann wall mounted boiler with copper pipework, isolation valves and a system filter — **Viessmann install, full re-pipe**Flow and return dropped fresh, service valve on every leg and a filter on the return before it was fired.

Worcester boiler with copper pipework, service valves and a MagnaClean filter — **Worcester with filter fitted**Four legs run and labelled, filter teed into the return, gauge positioned where somebody can actually read it.

Vaillant ecoFIT pure combi boiler with copper pipework and condensate pipe — **Vaillant ecoFIT swap**Old unit off, new one hung and piped, condensate taken to a proper termination rather than a nearby gully.

Alpha combi boiler installed in a loft on a ply board with insulated pipework and a CO alarm — **Combi relocated into the loft**Boarded out, mounted on ply, pipework insulated against the cold and a CO alarm fitted beside it.

Wall mounted boiler in a cellar with a MagnaClean filter and grey insulated pipework — **Cellar install**Hung off the wall, flue routed out and the filter placed where it can be cleaned without dismantling anything.

Worcester boiler installed on a stud wall with copper pipework and a magnetic filter — **Piped before the wall closed**Filter on and everything clipped while the stud was still open, so nothing needed chasing in later.

New Ideal combi boiler installed on a plastered wall with copper pipework — **Straight combi changeover**Gas and water connections renewed rather than reused, which is where most swaps get rushed.

New white boiler flue run and wall terminal fitted above a boiler — **Flue re-routed**New run out through the wall on a replacement, sealed and supported to spec.

Cylinders & plant

Stored hot water, vessels, manifolds and the controls that run them.

Vaillant system boiler beside a Tempest unvented hot water cylinder with insulated pipework — **Boiler and unvented cylinder**System boiler beside a Tempest cylinder with vessel and controls, the lot inside one airing cupboard.

Worcester system boiler and unvented hot water cylinder with expansion vessels — **System boiler and cylinder**What a house with two bathrooms needs, and what a combi was never going to manage.

Plant room with an OSO hot water cylinder, buffer vessel and insulated pipework — **Plant room, cylinder and buffer**Primaries insulated and labelled so anybody working on it later knows what is what.

Underfloor heating manifold with expansion vessel, pumps and copper pipework in a plant room — **Manifold and plant wall**Manifold, vessel, pumps and zone controls on one wall, all of it reachable.

Heating control board with a pump, filter, two zone valves and a programmer — **Two zones on one board**Pump, filter, both zone valves and the programmer laid out together, so the next fault takes minutes to find.

Copper heating pipework on a board with a magnetic filter, valves and pressure gauge — **Plant board**Everything readable and reachable. The opposite of a bag of pipes crammed behind a bath panel.

Vaillant heating pump with brass isolation valves and copper pipework in a cellar — **Pump and isolation**Valves either side of the pump and a drain point, so the next service does not mean emptying the system.

Radiators & pipework

Panels, columns, cast iron and the copper feeding them.

Two tall anthracite column radiators fitted in a period room — **Column rads, period room**Tails dropped through the floor so no pipework runs along the skirting.

Ornate gold painted cast iron column radiator — **Cast iron, refitted**Heavy when it is full, so the floor and the fixings get checked before it goes back on the wall.

White column radiator fitted under a window — **Column rad under a bay**Valves and tails renewed while we had the floor up anyway.

Tall anthracite vertical designer radiator fitted in a hallway — **Vertical rad, narrow wall**Where nothing horizontal was ever going to fit.

Anthracite flat panel radiator with chrome pipework in a hallway — **Convector replaced**Flat panel in, pipework dropped and clipped rather than snaking along the skirting.

Navy vertical designer radiator with copper brackets in a bathroom — **Designer rad, balanced in**Plumbed onto the circuit and balanced with the rest of the system rather than left to take what it wants.

Brushed gold ladder towel rail fitted in a tiled bathroom — **Towel rail on the circuit**Fitted, valved and balanced, not just hung on the wall and connected.

Copper heating pipes clipped neatly along a wall — **Primaries run and clipped**Even clip spacing and nothing resting on a joist to knock when it heats up.

Wet underfloor heating pipework laid across a floor before screeding — **Underfloor before screed**Clipped out, pressure tested, then left under pressure while the screed went over the top.

Boiler with copper pipework, magnetic filter and a pressure gauge reading 1.5 bar — **Set at 1.5 bar and signed off**Cleaned, filtered and pressurised before anybody called it finished.

Safety work

Not every visit ends with something new on the wall.

Gas boiler with a Danger Do Not Use safety warning notice attached after an inspection — **Classified and disconnected**A warning notice applied after a safety inspection. An unsafe appliance gets labelled and turned off, not quietly left running because it is inconvenient.

Reviews

What the customers said

Word for word from customer reviews — nothing rewritten, nothing tidied up.

★★★★★

Perfect professional service when my boiler was working fitted a new one the next day great price
Used again to get my bathroom fitted
Very clean and tidy reliable and very hardworking will use again

CCher C.Customer Review

★★★★★

Had a great experience and would 100% recommend! We had a leak in our washer and a previous leak under the bathroom sink. The team was able to address both issues and also caught a small leak in our washer hose that could have caused problems later. You can tell they put a lot of honesty and care into their work. We’ve had our fair share of bad plumber experiences, but with them, we really appreciated how we were shown the root of each problem and kept informed throughout. They also made sure to test everything multiple times to ensure the issues were fully resolved.

BBrad G.Customer Review

★★★★★

Amazing service from this company today. Was in desperate need of rescuing and they came out super quickly to solve the issue. They were extremely polite, clean and couldn’t have been more helpful. Highly recommended 🙏

OOlivia P.Customer Review

★★★★★

Very professional and great service.The leak was fixed promptly and with minimal mess.I would highly recommend their services to anyone needing a plumber

SStuart T.Customer Review

★★★★★

best plumbers they fixed my sink and made me and my parents very happy for the great service!

TTanya J.Customer Review

Get in touch

Book a quote

Ring and a Gas Safe registered engineer answers, not a script. Rather write it down? The form comes straight through and we come back the same day.

Ring us, any hour

0114 463 0405

No heat, no hot water or a boiler locked out — ring rather than email.

Hours24 hours, 7 days a week, bank holidays included
AreaSheffield and the surrounding areas
RegistrationAll gas work by a Gas Safe registered engineer
Gas emergencyNational Gas Emergency Service: 0800 111 999

Send us the details

No obligation. We’ll tell you straight whether it’s a repair or a replacement.

26 jobs, all our own photos

Combis, system boilers, relocations and changeovers.

Stored hot water, vessels, manifolds and the controls that run them.

Panels, columns, cast iron and the copper feeding them.

Not every visit ends with something new on the wall.

No heat, no hot water, or a boiler locked out?

What the customers said

Book a quote

Send us the details